Shure SLX4E R5 Drahtlos System

The SLX4 receiver makes setup easier than ever. Using Automatic Frequency Selection, the system quickly identifies a free channel and then synchronizes transmitter and receiver via infrared link. Included rack-mounting hardware, detachable antennas and other accessories ensure that SLX wireless systems are ready to go in no time. Also available is an SLX4L variant of the receiver with selectable logic function.


Functions:

• Automatic frequency selection
• Automatic frequency synchronization
• Microprocessor controlled predictive diversityA diversity receiver has two antennas to avoid drop-outs.Read moreTo the glossary
• 960 selectable frequencies per frequency band (depending on frequency versions)
• Freely selectable frequencies in 25 kHz steps
• Up to 14 compatible channels per frequency band
• Up to 24 MHz bandwidth
• Shure Audio Reference Companding with level-dependent compression ratio for outstanding sound quality with minimized noise floor
• Robust metal housing
• Rack mounting hardware included
• Removable ¼-lambda antennas
• Cable for antenna front mounting included
• Jack and XLR output
• Locking function for frequencyFrequency of a cyclic process, e.g. a sound wave, measured in hertz (Hz).Read moreTo the glossary and on/off switch.
• Volume control on the back
• Backlit multifunction LC display
• LED indicator for high frequency signal
• LED chain for audio level
• Low battery indicator
• Material for rack installation included
• Cable for antenna front mounting and BNC adapter included
• SLX4L variant of the receiver with selectable logic function available

Technical data:

• Power supply: PS21E
• Battery status: Yes
• Professional UHF diversity receiver for wireless audio transmission incl. pilot tone (32.768 kHz)
• Housing: metal design
• Frequency response: 45 Hz to 15 kHz (+/- 2 dB)
• Dynamic rangeRange between self-noise and maximum level. E.g. with a condenser microphone.Read moreGo to glossary: >100 dB (A)
• Total harmonic distortion (at +/- 38 kHz deviation, 1 kHz modulation): <0.5% (typical)
• Audio output level (at +/- 38 kHz deviation, 1 kHz): XLR -13 dBV; Jack - 2 dBV
• Output impedance: XLR 200 Ohm, Jack 1 kOhm
• Image frequency rejection: >70 dB (typical)
• Carrier frequency range: 470 - 865 MHz (available frequencies depend on national regulations)
• RF sensitivityOutput voltage produced by the microphone at a given sound pressure.Read moreGo to glossary: -105 dBm for 12 dB SINAD (typical).
• Dimensions (H x W x D): 42 x 197 x 134 mm
• Weight: 816 g
• Power supply: 12 - 18 Vdc, 150 mA, external power supply included
• Range: 100 m under normal conditions