Ram Audio S 1500 - PA Power Amplifier 2 x 880 W 2 Ohms
The state-of-the-art QuantaPulse EVO switched-mode power supply of the new S Series amplifiers provides major benefits: it increases efficiency and reliability, generates less heat and keeps the weight down. While delivering high output power S series amplifiers tip the scales at around 8 kg only.
S Series power amplifiers are available with 2 and 4 channels and output ratings from 1.5 to 6 kW. Housed in 30 cm deep, 2U rackmountable chassis the S series uses surface-mount technology with high component density for maximum reliability.
Main Features- QuantaPulse™ EVO switched-mode power supply for maximum efficiency, increased output and reliability
- five 2-channel models with up to 4 kW output power
- very light weight (8 kg), 2U and 30 cm depth
- electronic protection circuits
- high component density surface-mount technology (SMT) provides mechanical strength and reliable operation
- Neutrik XLR and Speakon connectors
QuantaPulse™ Technology: The Soft Switching Resonant QuantaPulse Power Supply is designed to provide plenty of power when needed monitoring the necessary parameters of voltage and current for a controlled performance at all times. Bi-directional data flow between the power supply and power amp module. Two very important characteristics of the QuantaPulse power supply are the optimization against over-voltages and superior reliability.
Technical data:Product type: | Power Amplifiers |
Type: | PA Power Amplifiers |
Rated ouput power (1kHz @ 2 Ohms): | 2 x 880 W |
Rated ouput power (1kHz @ 4 Ohms): | 2 x 575 W |
Rated ouput power (1kHz @ 8 Ohms): | 2 x 325 W |
Rated ouput power (1 kHz @ 4 Ohms, bridged): | 1760 W |
Rated ouput power (1kHz @ 8 Ohms, bridged): | 1150 W |
High Z 100Vrms / 140Vpeak: | 1 x 1140W |
Output circuitry: | Class H |
Frequency response: | 20 - 20000 Hz |
Total Harmonic Distortion (THD): | |
Signal-to-noise ratio: | 112 dB |
Damping factor (20Hz-500Hz @8ohm): | > 500 |
Crosstalk: | > 75 dB |
Gain: | 26 / 32 / 38 dB |
Input sensitivity: | 2.6 / 1.3 / 0.6 V |
Input impedance: | (balanced) 20 k Ohm(s) |
Input impedance: | (unbalanced) 10 k Ohm(s) |
Protection circuits: | DC voltage |
Protection circuits: | high frequency |
Protection circuits: | mismatching |
Protection circuits: | on/off transients |
Protection circuits: | open outputs |
Protection circuits: | power on muting |
Protection circuits: | short circuit |
Protection circuits: | Soft start |
Protection circuits: | thermal overload |
Controls: | 2 x volume |
Controls: | dual/bridge switch |
Controls: | Power |
Indicators: | Clipping |
Indicators: | fault |
Indicators: | ready |
Indicators: | signal |
Indicators: | temperature |
Line inputs: | 2 |
Line input connectors: | XLR |
Line outputs: | 2 |
Line output connectors: | XLR |
Loudspeaker outputs: | 2 |
Speaker output connections: | Speakon |
Cooling: | fan |
Operating voltage: | 230 V |
Power consumption @ full load: | 4A |
Width: | 483 mm |
Height: | 89 mm |
Depth: | 310 mm |
Weight: | 8 kg |
Mon-Fri: | 08:00 am – 05:00 pm |
Document type | File size | |
Information about the product
(7.87 MB)
|
7.87 MB | |
Information about the product
(0.26 MB)
|
0.26 MB | |
Information about the product
(2.11 MB)
|
2.11 MB |
Mon-Fri: | 08:00 am – 05:00 pm |
Mon-Fri: | 08:00 am – 05:00 pm |