DAP-Audio CA-2150 - 300 watt amplifier 2x 150 watt - bridge and stereo mode

The DAP CA-2150 is a 2x 150 watt amplifier for a compact 19-inch installation with a 1 unit height. Equipped with Class D technology and SMPS, the CA-2150 has all the necessary functionalities for today's user.

This 2-channel model has XLR and Jack inputs. Available outputs are speakON and 6.3 mm Jack with the option to switch between stereo and bridge mode. In addition, the gain is adjustable per channel.

When a channel signal is causing distortion, a LED signal is indicating you to decrease the source signal level. It is not only protected from clipping, but also from overloading and overheating due to soft start technology.Technical data:

2 Ohms Stable:	Yes
Output per channel into 8 ohms at 1 kHz:	90 W
Output per channel into 4 ohm at 1 kHz:	150 W
Output per channel into 2 ohm at 1 kHz:	230 W
Bridge Output into 8 ohms at 1 kHz:	190 W
Bridge Output into 4 ohms at 1 kHz:	275 W
Output Channels:	2
Output Mode:	Bridge / Stereo
Output Connector:	NL4 / TRS unbalanced 6.3 mm
Mono Input Connector:	3-pin XLR / TRS balanced 6.3 mm
THD Level:	Signal-to-noise Ratio:> 96 dB
SLEW Rate:	15 V/µs
Amp Technology:	Class D
Damping Factor:	180:1
Frequency Response Minimum:	20 Hz
Frequency Response Maximum:	20 Hz
Power Supply:	220V-240 VAC 50 Hz
Power Consumption:	425 W
Height (mm):	44 mm
Width (mm):	484 mm
Length (mm):	281 mm
Rack Units:	1 U
Weight:	3.7 kg
Electronic Protection:	Clip limiter (fixed) / DC voltage / Overheat / Overload / Short circuit / Softstart